Start your Cummins with ease using the Cummins Crankshaft Barring Tool. Install this tool and you'll never back a bolt out of the damper when trying to reach TDC and overshoot again. Especially useful when removing and reinstalling a transmission, and there is no need to use a pry bar to rotate the engine to R&R converter bolts. The Cummins Crankshaft Barring tool accepts 1/2-inch drive ratchet, is compatible with factory crank bolts and roll pins, is built from 1018 steel and is corrosion-resistant. Plus it doesn’t require being removed after installation, and it works with Vibratech Fluidampr and factory dampers. MSRP: $69.95 (855-839-5040/www.fleeceperformance.com)